Thus, “intrinsic” permeability refers to the passive lipoidal or carrier-mediated permeability of the test compound in its uncharged form. The mathematical treatment of such “normalization” and use of the pCEL-X software is described in detail in Appendix A. The objective of our study was to convert the measured apparent permeability, Papp, from two different model systems

to a common (intrinsic) standard state. The hydrodynamic environments of the two permeability assays (in vitro cell monolayer and in situ brain perfusion) are very different. In the meta-analysis of several in vitro endothelial cell models of blood–brain Apoptosis inhibitor barrier permeability (benchmarked by in situ brain perfusion measurements), Avdeef (2011) found that log Papp poorly correlated to log PCin situ. The r2 factors for the porcine, bovine, rodent, and human in vitro models were 0.33, 0.09, 0.04, and 0.14, respectively. However, when the log of the intrinsic permeability coefficients were compared, the corresponding r2 values rose to 0.57–0.58. Published Papp measured in other in vitro porcine BBB monoculture models ( Franke et al., 1999, Franke et al., 2000, Lohmann et al., 2002 and Zhang et al., 2006) and rodent in situ brain perfusion data ( Dagenais et al., 2009 and Avdeef, 2012) were collected from the literature and BAY 73-4506 nmr analyzed in pCEL-X to correct for ABL

and ionization (for in vitro and in vivo data), paracellular permeability and filter restriction (for in vitro data only) to derive the intrinsic transcellular permeability Adenosine P0. The in vitro P0 were plotted against the P0in situ to obtain the in vitro–in vivo correlation (IVIVC; Avdeef, 2011). In the present study, the P0 values of the compounds analyzed were incorporated into the previous IVIVC data. The linear regression coefficient was obtained for the pooled in vitro and in vivo (in situ) data. Table 1 lists the molecules analyzed in the study along with their measured and predicted physicochemical properties. Table 2 summarizes the in vitro PBEC measured

data, together with the characteristics of the permeability experiments. Table 3 lists the permeability model refinement results. Table 4 summarizes the averaged log P0in situ values compiled from published rodent in situ brain perfusion studies from multiple sources ( Avdeef, 2012). These log P0in situ values were compared to log P0 based on PBEC measurements in the IVIVC. To determine the intrinsic transcellular permeability (P0) of propranolol, the permeability assay was first carried out at multiple pH using cell monolayers grown on Corning Transwell® polyester membrane (Transwell®-Clear) filter inserts. The polyester membrane was preferred because of cell visibility under the microscope. pH-dependent permeability was expected for propranolol.