“
“The mechanical damage caused by the insertion of a foreign body into living tissue is inevitable, especially when a considerable stiffness mismatch is present, as in the case of micromachined neural implants and brain tissue. However, the response surface model based on a central composite experimental design described in this study showed that for particular configurations of the implant tip angle, width, thickness or insertion speed, some of these factors could be safely increased without causing an unwanted significant force or tissue dimpling increase. The model covers chisel tip angles between 10 degrees and 50 degrees, implant

widths within the 200-400 mu m range and thicknesses between 50 and 150 mu m. The insertion speed has been www.selleckchem.com/products/mi-503.html varied from 10 up to 100 mu m s(-1) to

reach a final insertion depth of 6 mm. Coating the implant with parylene C proved to be beneficial in reducing the friction between the implant and the surrounding tissue. Successfully validated for a particular implant geometry, this model could be used as an insertion behavior prediction tool for the design optimization of future neural implants.”
“Objective: To construct an ideal extracorporeal life support (ECLS) circuit in terms of hemodynamic performance, each component of the circuit should be evaluated. Most cannulae manufacturers evaluate their products using water as the priming solution. We conducted this study to evaluate the different sizes https://www.selleckchem.com/products/lxh254.html of arterial and venous cannulae in a simulated neonatal ECLS circuit primed with human

blood.\n\nMethods: The simulated neonatal ECLS circuit was composed of a Capiox Baby RX05 oxygenator, a Rotaflow centrifugal pump and a heater & cooler unit. Three Medtronic Bio-Medicus arterial cannulae (8Fr, 10Fr, 12Fr) and three venous Galardin datasheet cannulae (10Fr, 12Fr, 14Fr) were tested in seven combinations (8A-10V, 8A-12V, 10A-10V, 10A-12V, 10A-14V, 12A-12V, 12A-14V). All the experiments were conducted using human blood at a hematocrit of 40% and at a constant temperature of 37 degrees C. The “tip to tip” priming volume of the entire circuit was 135ml. The blood volume of the pseudo patient was 500ml.\n\nResults: Flow rates increased linearly with increasing size in both venous and arterial cannulae at the same pump speeds. The increase in flow rate was greater when changing the arterial cannulae (next size larger) compared to changing the venous cannulae (next size larger). The pressure drops of the arterial cannula were correlated with the flow rates, regardless of the pseudo patient pressure and the venous cannula used simultaneously.\n\nConclusions: The results show the difference in flow ranges and pressure drops of seven combinations of arterial and venous cannulae. It also suggests that the arterial cannula, not the venous cannula, has greater impact on the flow rate when a centrifugal pump is used in a neonatal ECLS circuit.