2-mm pores) and washed with water and then acetone. The CNTs were then dispersed in 5 mL of N,Selleck Thiazovivin N-dimethylformamide using an ultrasonic bath and precipitated again with acetone, filtered,

and washed with acetone. Finally, the CNTs were treated with diluted NaOH solution (30 min in the ultrasonic bath), filtered, washed with water followed by acetone, and dried. Figure 1 Functionalization of SWCNTs. Preparation of the modified electrode Firstly, a PB film was electropolymerized at the Pt electrode surface in an unstirred fresh 2 mM K3Fe(CN)6 + 2 mM FeCl3. 6H2O in 0.1 M KCl + 1 mM HCl aqueous solution by cyclic voltammetry in the potential range of −0.2 to 1.0 V at a scan rate of 0.1 V s−1. Different amounts of the functionalized nanotubes AZD1152 cost (usually 1 mg/mL)

were dispersed in bidistilled water by sonication for 1 h. The selected amount of GOx (1 mg/mL) was then added to the CNTs solution. Afterwards, pyrrole was added (at a concentration of 0.5 M) to the GOx and SWCNTs-PhSO3 − mixture, and the electropolymerization was performed at current densities of 0.1, 0.2, or 0.5 mA cm−2 for different times. The electropolymerization was carried out at pH 7.4. After the electropolymerization, the composite film (PPY/GOx/SWCNTs-PhSO3 −/PB) was subjected to overoxidation by cycling the potential from −0.2 to 1 V for 50 cycles at 0.1 V s−1 in a phosphate Everolimus buffer solution at pH 7.4. For comparison, PPY/GOx/SWCNTs-PhSO3 −, PPY/GOx/PB, and PPY/GOx films have been also obtained. Results and discussion PB-modified electrodes Palbociclib have been synthesized by the simple and versatile electrochemical method proposed by Itaya et al. [10] based on the reduction of a ferric-ferricyanide solution as described in the ‘Methods’ section. The procedure can be adopted with different

electrode materials (platinum, gold, and glassy carbon), and a high stability of the layer deposited through successive cycling was demonstrated [10]. The typical cyclic voltammogram recorded during PB film electrosynthesis, as described in the Methods section, is shown in Figure 2. Two sets of peaks can be observed in cyclic voltammetry recordings for PB/Pt-modified electrodes synthesis which correspond to the reduction and oxidation of PB to Prussian white (E 1/2 = 0.2 V) and to Berlin green (E 1/2 = 0.9 V), respectively. Figure 2 Cyclic voltammograms of Prussian blue film electrosynthesis at Pt electrode. Then the pyrrole electropolymerization was carried out galvanostatically at PB/Pt electrode surface. The electropolymerization was performed in 0.1 M phosphate buffer solution at a pH of 7.4, above the isoelectric point of the glucose oxidase, in order to provide an overall negative charge so that the glucose oxidase can electrostatically attach to the PPY backbone. The overoxidation of enzyme-doped PPY electrodes leads to a loss of the PPY electroactivity and to an enhanced sensitivity and selectivity to glucose.